Product Manual

reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help
- This device and its antenna(s) must not be co-located or operating in conjunction with any
other antenna or transmitter.
RF Exposure Information and Statement :
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance of 20
cm between the radiator and your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter
Instructions to the OEM/Integrator:
This module has been granted modular approval for mobile applications. OEM integrators for
host products may use the module in their final products without additional FCC certification if
they meet the following conditions. Otherwise, Additional FCC approvals must be obtained.
 The OEM must comply with the FCC labeling requirements. If the module’s label is not
visible when installed, then an additional permanent label must be applied on the outside of
the finished product which states: ”Contains transmitter module FCC ID:
2AWGLLSD1NFST39NFC0,Additionally, the following statement should be included on
the label and in the final product’s user manual:
“This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interferences, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.”
 The user’s manual for the host product must clearly indicate the operating requirements
and conditions that must be observed to ensure compliance with current FCC RF exposure
guidelines.
 The final host / module combination may also need to be evaluated against the FCC Part
15B criteria for unintentional radiators in order to be properly authorized for operation as a
Part 15 digital device.
 This Module is limited modular approval, it is limited to OEM installation ONLY.
 The module is limited to installation in mobile application.
 A separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and difference antenna configurations.
 The OEM integrator is responsible for ensuring that the end-user has no manual instruction
to remove or install module.
 The Grantee will provide guidance to the Host Manufacturer for compliance with the Part
15B requirements if requested.