Operation Manual

3
other item on the truck.
3. DO NOT OVER-TIGHTEN THE CABLES TO THE SPLITTER. HAND-TIGHTEN ONLY.
4. From the cab, run the 3m extension cable from the TPMS-CANBUS down either through
the firewall or along the side post and through the floor board ending up under the driver
seat.
5. Connect the single end of the Splitter to the 3m extension cable.
6. Locate a place between the steer wheels and attach the 3m cable antenna pointing
downwards. Be sure not to locate near a heat source or where a moving part will be in
contact with the antenna.
7. Run the antenna cable along the left (driver) side of the vehicle and connect to one of the
two female ends of the Splitter.
8. DO NOT OVER-TIGHTEN THE CABLES TO THE SPLITTER. HAND-TIGHTEN ONLY.
Wrap with electrical tape.
Warnings
FCC Requirement :
（1）All products:
changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may cause
undesired operation.
（2）Class B device warning:
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy, and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
– Reorient or relocate the receiving antenna.