Operation Manual

2
Standalone
‣ Connect WRN-G harness to the Valor TPMS-CANBUS
‣ Connect power to the WRN-G harness
Peolenet
‣ Connect DFL harness to vehicle CAN/power
‣ Pulg other end of DFL harness into Valor TPMS-CANBUS
3. Two ST5.5 self-tapping screws are used for fixation.
4. Find a power source at fuse panel. Connect the power leads to the power source, and
key on power.
5. Connect the 3M Extension to the antenna pole on the TPMS-CANBUS.
6. CANBUS is one of the components of the tire pressure and temperature monitoring
system that cannot be used alone.
Installing Antennas
1. Locate a place between the rear drive wheels. Attach the 8m antenna pointing
downwards. Be sure not to locate near a heat source or where a moving part will be in
contact with the antenna.
2. Run the cable along the left (driver) side of the vehicle to the front under the driver seat.
Using wire ties, attach the cable to vehicle wiring harness (normally runs along the frame).
If extra cable, loop up and wire tie out of the way making sure it does not interfere with any