Operation Manual

ManualsBrandsSHANGHAI BAOLONG AUTOMOTIVE ManualsAutomotiveTPMS-CANBUS

Table Of Contents

OPERATION MANUAL OF TPMS-CANBUS

MODEL: QY1195A5

Thank you for choosing our TPMS-CANBUS. This guide instructs the technician how to

properly mount and dismount a Baolong TPMS-CANBUS receiver.

Introduction of TPMS-CANBUS

TPMS-CANBUS is the receive module in TPMS. It has RF transceiver function, CAN

line transceiver function, data storage read function, and so on.

Its RF parameters are as follows:

Frequency: 433.92MHz;

Send Power: -20dBm

≥

transmitting power

≥

-60dBm;

Receiving sensitivity:

≥

100dBm

Can parameters are as follows:

Band rate: 250kbps;

Power supply: 12V/24V.

TPMS-CANBUS receive transmitter RF information, parse the data, store the data in a

local storage medium and send it over the CAN line. And through the relevant tools to learn

the transmitter, download data, set the baseline and other function.

TPMS-CANBUS is used to monitor the tire pressure temperature status, refrigerated

truck temperature status. Achieve the following alarm function:

Low Pressure Warning

High Pressure Warning

High Temperature Warning

Installing the TPMS-CANBUS unit

1. Install the CANbus behind the engine cowl.

2. Connect the supplied harness to the 6-pin connector on the Valor TPMS-CANBUS:

Summary of content (4 pages)

PAGE 1
OPERATION MANUAL OF TPMS-CANBUS MODEL: QY1195A5 Thank you for choosing our TPMS-CANBUS. This guide instructs the technician how to properly mount and dismount a Baolong TPMS-CANBUS receiver. Introduction of TPMS-CANBUS TPMS-CANBUS is the receive module in TPMS. It has RF transceiver function, CAN line transceiver function, data storage read function, and so on. Its RF parameters are as follows: Frequency: 433.
PAGE 2
Standalone ‣ Connect WRN-G harness to the Valor TPMS-CANBUS ‣ Connect power to the WRN-G harness Peolenet ‣ Connect DFL harness to vehicle CAN/power ‣ Pulg other end of DFL harness into Valor TPMS-CANBUS 3. Two ST5.5 self-tapping screws are used for fixation. 4. Find a power source at fuse panel. Connect the power leads to the power source, and key on power. 5. Connect the 3M Extension to the antenna pole on the TPMS-CANBUS. 6.
PAGE 3
other item on the truck. 3. DO NOT OVER-TIGHTEN THE CABLES TO THE SPLITTER. HAND-TIGHTEN ONLY. 4. From the cab, run the 3m extension cable from the TPMS-CANBUS down either through the firewall or along the side post and through the floor board ending up under the driver seat. 5. Connect the single end of the Splitter to the 3m extension cable. 6. Locate a place between the steer wheels and attach the 3m cable antenna pointing downwards.
PAGE 4
– Increase the separation between the equipment and receiver. – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. – Consult the dealer or an experienced radio/TV technician for help. （5）FCC 20cm Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.