User's Manual

11
Part Ⅸ TROUBLE SHOOTING
Problems
Possible Reasons
Solutions
Both pressure value and
temperature value of all tyres are
"000" shown on the display
Problems of antenna
connection
Check antenna connection
The antenna is damaged
(if all transmitters are well)
Replace antenna
Display malfunction
Use a pair of transmitter & ID
module and TPMS Smart Tool to
confirm. If it doesn’t work, replace it
The pressure and temperature
values are ”000” at some
transmitter positions
(After start the display)
Problem of transmitter
Use TPMS Smart Tool to check it
Problems of ID module
Pull out the ID module and re-plug
in, then restart the display.
If problem still exist, pull out the ID
module and plug in other ID module
position, then restart the display.
If problem still exist, replace the ID
module, then restart the display
The pressure value is “000”, but
temperature value is normal.
Transmitter is damaged
Replace the transmitter
No values shown on the display
and all icon indicators don’t
shine
Display is turned off
Turn on Switch on the back of
display
Power cord is not properly
installed
Check power cord connection
The display is damaged
Replace display
“no id” show on display
ID modules not plugged in
Plug in ID module
Dash “- - -”shows on the display
(When the data transmission
was interrupted)
System failure
Restart the system
Surrounding interference
Move to another place
Problem of transmitter
Use TPMS Smart Tool to check it
Problems of ID module
Pull out the ID module and re-plug in,
then restart the system. If problem
still exist, pull out the ID module and
plug in other ID module position, then
restart the system. If problem still
exist, replace the ID module
000 shown on the display after a
transmitter replacement.
The ID number for the new
transmitter is not programmed
into the display
Replace the old ID module with a new
one. Restart the system and set
baseline pressure
Baseline pressure not set
Set baseline pressure
(High or low) Pressure Warning
at more or all transmitter
positions after installation
Baseline pressure not set
Set up the baseline pressure for each
axle
The buzzer is continuously
beeping and nothing shown on
the display
The display does not work
Replace the display
After the trailer is disconnected
with the tractor, the trailer's data
still shows on the display.
Wait for 10 minutes
The trailer’s data cannot be
shown on display
Display does not match with
Vehicle ID Box
Make sure Display and Vehicle ID
Box has the same ID number
Trailer registration failed
Do trailer registration again
Trailer Box malfunction
Replace Trailer Box, and do
registration again
Vehicle ID Box malfunction
Replace Vehicle ID Box and Display,
and do registration again