User's Manual

Rotate the wheels between position “2A” and “2D”

* Back of Display * Back of Trailer Box

Change their corresponding ID modules’ position, restart display and trailer box

Part Ⅵ REPLACEMENT OF A DAMAGED TRANSMITTER

After replacing the damaged transmitter, you should also replace its ID module.

1. Replace the malfunctioned transmitter

2. Replace the corresponding ID module

3. Restart display and reset baseline pressure

NOTE: If you have a blank ID module, you can use the TPMS Smart Tool to write ID code

into it (Refer to the manual of TPMS Smart Tool).

Part Ⅶ RESTART DISPLAY AND TRAILER BOX

The system has to be restarted to re-identify the tyre ID in the following situation(s):

1. Wheel rotation;

2. Replacement of transmitter & ID module;

3. Trailer change.

To restart the system, turn off the Switch on the display and/or the Trailer Box and then turn

them on again.

Turn off and turn back on to restart the display Turn off and turn back on to restart the Trailer Box