User's Manual

1.5 FCC's authentication announcement

This device complies with part 15 of the FCC rules and Industry Canada licence-exempt

RSS standard(s). Operation is subject to the following two conditions (1) this device may

not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. You can test that if this equipment does cause harmful interference to

radio or television reception by turning the equipment off and on.

Caution content: changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate the equipment.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils

radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)

l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout

brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le

fonctionnement.

1.6 European regulations announcements

This device complies with all European Electromagnetic compatibility regulations (95/54/EC

and EN300 220-1). The equipment has been tested and found to comply with the above

regulations, and in addition it meets the requirements for low powered

transmitters/receivers as defined by the relevant radio approval authority. The regulations

are designed to provide reasonable protection against harmful interference or susceptibility.

1.7 CE directive announcement

This device complies with the essential protection requirements of Council Directive

89/336/EEC on the approximation of the law of the Member states relating to

electromagnetic compatibility. Operation is subject to the following two conditions: (1) this

device may not cause harmful interference, and (2) this device can accept any interference

received, including interference that may cause undesired operation.