User's Manual

8
1.3.2 Installation ID Module
As it’s shown in the picture, the ID module is pasted on the transmitter for convenient
installation. Every ID module has a unique ID number like
DF101D96; this number is only accordant with the attached
transmitter.
When installing the ID module, remove it from the
transmitter and then insert the ID module to the display.
Use the same procedure to install the other ID modules
and make sure your installation is correct.
1.3.3 Removing Transmitter
1.3.3.1 Deflate the tire and remove the wheel weights from the rim. Push the tire bead away
from the rim. Make sure to always set the bead breaker at least 90 degrees from the valve
stem to avoid damaging the transmitter.
1.3.3.2 Firmly fix the wheel on the turntable clamps. (If the mounting head of the tire
changer is positioned at 12 o'clock, then the valve stem should be at the 11 o'clock position.)
Apply lubricant to both tire bead and rim, and then demount the upper tire bead。
1.3.3.3 Use the same procedure to demount the lower tire bead. (If the mounting head of
the tire changer is at the 12 o'clock position, then the valve should also be at the 12 o'clock
position.)
1.3.3.4 Final inspection: Visually inspect the rim and transmitter to ensure no damage has
occurred.
1.4 PARAMETERS OF THE PRODUCTS
Transmitter
Weight: 123g (4.34 oz.)
Dimensions: 8.3 x 4.9 x 3.4 cm (3.27x1.93x1.34 inch)
Operating Temperature Range: -40°C to 85°C (-40°F to 185°F)
Pressure Accuracy: ±0.04 Bar / 0.58PSI (at 0°C ~85°C)
Temperature Accuracy: ± 3°C /5.4 °F(at
-20℃～70℃) ，± 5°C /9 °F(-40℃～20℃、70℃～100℃)
Battery Life: 5years at 20 hours driving per day
Maximum Range: 14Bar (203PSI)
Frequency: 433.92MHz