User's Manual

NOTE: The transmitter must be positioned in the lowest spot possible and installed

beside the tire valve in order to know its approximate location after the tire has been

mounted.

NOTE: When fixing the transmitter on the rim, make sure the section of steel strap

installed through the transmitter is complete NOT TOOTHED.

1.3.1.3 Mount the tire on the rim, inflate tire to standard cold inflation pressure specified on

tire sidewall and dynamic balance the wheel before it is put back on the vehicle.

Ensure that the tire beads and mounting hook do not touch the transmitter

during mounting. Pay attention to the transmitter antenna not be clamped by tire

bead and broken by mounting hook. DO NOT inflate tire higher than maximum

pressure stamped on tire sidewall.

1.3.1.4 Use the same procedure to install the other transmitters. And record all ID numbers

labeled on the rim in the Annex table so that you can attach the ID modules to the proper

location.