User`s manual

JK-E01 User’s Manual
5 Usage of JK-E01 Module
- 5 -
st Page 5.1 Print Self-te
After JK-E01 module is installed, refer to printer user’s manual to print a self-test page. The self-test
information relative to Ethernet Interface is as below:
Figure 5.1.1 Self-test Page Information
Note:
Interface Type: the type is for Ethernet
Interface Firmware: shows the firmware version of interface module
IP Address: shows the currently used IP Address of interface module
MAC Address: shows hardware MAC Address of interface module
GATEWAY
DHCP: shows if web-configuring parameters as IP Address are obtained by DHCP. Disabled means
not in use of DHCP, and Enabled means in use of DHCP mode.
5.2 Device Search and Parameter Configuration
The tool of NetWinConfig.exe could search and connect to JK-E01 module in network and configure it
with web parameter.
Before running the software, SUBNET Mask of host machine set should consist with that of Ethernet
interface module. To ensure host PC and interface module under one SUBNET, IP Address of host PC is
set under same SUBNET address.
Notice:
In case of configuring JK-E01 module with web parameter in use of configuration tools, if many network
devices with same IP Address are connected under one SUBNET at same time(for example, many
interface modules all use default settings), the communication could not work normally due to a collision
existing in IP Address. Therefore, when JK-E01 module with default settings is configured with network
parameter, for each time only one Ethernet interface device could be connected, and you should ensure
that the configured IP Address is different. To avoid the collision between the IP Addresses of interface
module and other host PC, interface module and host PC for configuration should be set in a separated
network, for example, they could be connected to a separated hub or mutual web line for single device
(The joint line at two ends of web line can connect data receiving and transmitting signals across, host
SUBNET Mask