User`s manual

JK-E01 User’s Manual
5.6 HTTP functions
- 15 -
JK-E01 module can offer HTTP service that it uses the browser at the host to show the printer
status and the module status based on WEB and proceeds interface module configuration and
test-page printing. The port number used for this service is 80 TCP port.
The user should first get IP address of JK-E01 module via the self-test page or special
configuration tool when using it. Then input IP address in browser address list to inquire
the printer status and the interface module via WEB with details as below:
Start Internet browser and input the printer IP address, then you can see the interface status page.
Click “Refresh” button to refresh current status shown as below:
Figure 5.6.1 Show interface status page
When clicking “Printer Status”, you can check the printer status page connecting with JK-E01 module. If
it shows abnormal status, red words shall be shown. Click “Refresh” button to refresh
current status and click “ Print Test Page” to print a self-test page shown as Figure 5.6.2:
Figure 5.6.2 Show printer status’ page