User`s manual

JK-E01 User’s Manual
¾ Set network parameters as IP Address
Select the device in list box of main window, and click the button “IP Address Setting” to enter
- 7 -
the configuration window for “Setting TCP/IP” (Shown as figure 5.2.2). So you can set the
configuration of web parameters as IP Address of printer.
Figure 5.2.2 Configuring Web Parameter Window
Via this window, two low:
(DHCP)”, and then IP Address, Subnet Mask and Gateway
” to finish it after the configuration.
¾
lick button “Ethernet Card Update” to
enter the firmware upgrade window (shown as figure 5.2.3).
ways for the configuration can be used as be
1) First: select “Dynamic IP Address
could be obtained automatically via DHCP Protocols;
2) Second: select “Fixed IP Address”, set IP Address, Subnet Mask and Gateway by hand.
Click “OK
Firmware upgrade of JK-E01 module
Select the device in list box of main window, and then c
Figure 5.2.3 Firmware Upgrade Window