User manual
BTP-M280 User’s Manual
- 17 -
4) FEED button7
Press the button while turning on the printer, a self-test page
will be printed.
In the normal status, press the FEED button for a short time,
the printer will feed paper one line at a time. Under continuous
paper mode, hold the FEED button, the printer will feed paper
constantly. Under marked paper mode, it will feed paper to the
next mark.
In HP error status, hold the FEED button for a long time, the
printer will recover from HP error and start carriage verify check
In cutter error status, hold the FEED button for a long time, the
printer will recover from cutter error and start cut.
In error status other than described above, press FEED button,
the printer will have no action.
5) Power switch8
Turn on/off the printer. “O” is to turn off the printer; “—” is to turn
on the printer.
6) Back cover latch9
Catch back cover latch and pull it out to open the back cover.
7) Paper near end sensor19.
Detect the status of paper roll. If paper near end, the PAPER
LED will on, the ERROR LED will flash and indicate user to
replace paper. The printer will continue printing until the paper is
end.
8) Paper sensor21
Paper sensor is used to detect the printer with or without paper.