Service manual

Confidential BTP-M280 Service Manual
- 15 -
4.2.3 Disassemble the Stationary Blade Cutter Module
Pictures
Instructions
Offload one E-ring from one side of the stationary blade
shaft with the sharp-nose pliers and pull the shaft as the
arrow shown in the fugure, take the stationary blade
module off.
Unscrew the two screws (M3x5) as shown with the
screw driver, separate the cutter holder and the
stationary blade.
Note:
 Handle the stationary blade carefully to avoid injury.
 Handle the stationary blade carefully to avoid
damaging the blade with hard material.
Unscrew the two screws (ST2.9x6) as shown with the
screw driver, separate right holder and the left holder of
the stationary blade.