Installation manual

BTP-R880NP Installation manual
Font B: 0.25 mm {0.01"} (2 dots)
Kanji: 0.125 mm {0.005"} (1 dot)
Programmable by command
7) Printing speed: 230 mm/s (Max) {9.05"/s}
54.3 LPS maximum (4.23 mm/feed)
5.2 Auto Cutter Specifications
Item Parameter Remarks
Cutter type Slide cutter (Guillotine type)
Cutting time 500ms The time that one cut takes.
Cutting interval 3s 20 times/min. (Max.)
Paper type Thickness: 0.06 – 0.1mm
Thermal paper or paper with the
same thickness
Operation voltage 24VDC
Max. static current 1.2A 24V DC
Cutter lifetime
1, 800,000 cuts
(with reference paper）
Full cut or Partial cut
5.3 Interfaces
USB is fixed on board; all others (Serial Interface(RS232), Parallel
Interface(IEEE1284), Ethernet Interface, WLAN) are daughter boards.
5.4 Electric Parameters of the Power Supply
Item Parameter
Supply voltage 24VDC±5%
Current consumption
Mean: approximately 2.0A (12.5% duty ratio)
Peak: Approximately 10 A
Ripple & Noise < 240mVp-p
Power Connector
1 --- Positive (+24V)
2 --- GND
3 --- NC.
Caution:
Please use the power adapter that is supplied with the printer or an equivalent
type.
5.5 Environmental Conditions
1) Operating temperature and humidity: 5～45℃，20 ~ 80% RH
(No dew condensation)
- 14 -