Installation manual

BTP-R880NP Installation manual
 Ending hexadecimal dumping function
Hexadecimal dump mode can be ended by turning off the power, or by pressing
the FEED button three times.
4.3 LED and Buzzers
4.3.1 LED
LED Status Description
On Printer is powered on
Power Indicator (Green)
(POWER)
Off Printer is powered off
Off Printer is in normal status
Error Indicator (Red)
(ERROR)
Flash
Printer is in error status or Paper
near end
4.3.2 Description of LED and Error Status
Error information ERROR LED Buzzer
Print head is overheating Six times Six times
Input voltage is abnormal Five times Five times
Cutter Error Four times Four times
Cover Is Open Three times Three times
Paper End Twice Twice
Paper near end Flashing slowly No sound
Finding mark error or verify failed Flashing slowly No sound
Caution:
The temperature of the print-head is detected by means of a thermistor sensor.
If the temperature of the print-head becomes higher than 65℃, the protection
circuit of the printer will force the printer to stop printing.
5 Specifications
5.1 General Specifications
1) Printing method: Direct line thermal printing
2) Dot density: 203 DPI(H) ×180 DPI(V)
3) Printing direction: Unidirectional with friction feed
4) Printing width (max): 80mm {2.52 "}, 640 dot positions
5) Characters per line (default): Font A: 42
Font B: 56
Kanji: 21
6) Character spacing (default): Font A: 0.25 mm {0.01"} (2 dots)
- 13 -