Installation manual

BTP-R880NP Installation manual
3.3Loading the Paper Roll
Note: Be sure to use paper rolls that meet the specifications. Do not use paper rolls
that have the paper glued to the core because the printer cannot detect the
paper end correctly.
1) Turn off the printer.
2) Open the printer top cover, as in the following figure.
3) Put the paper roll into the paper holder. See figure below.
Note: Recommend paper
Paper type Manufactory
TF50KS-E2C,TF50KS-E Nippon Paper Industries Co., Ltd
F70NA FUJI PHOTO FILM Co., Ltd
F240AC/F220-VP,FV230A1,PA220AG,HP220A Mitsubishi Paper Mill Co., Ltd.
PD150R,PD160R OJI Paper Co.,Ltd.
F5041，F5051，P5045，P5055 Mitsubishi HitTec Paper Flensburg GmbH
KF50，KP440 Kanzan Spezialpapiere GmbH
KT55F20，KT58F20，KT55HS Papier-fabrik August Koehler AG
P300，P350，P530 Kanzaki Specialty Paper
Caution:
 Adjust the paper width by adjusting the paper guides according to the paper
type used.
 Make sure that the paper roll is cut according to the requirement below before
loading:
 Make sure that the heat sensitive side of paper faces the print head and the
rolling direction of paper meets the requirements. (See drawings under the top
cover). Note: If needed the heat sensitive side of the paper can be found by
scratching both sides of the paper with a hard object. The scratches on heat
- 8 -