User Manual

JK-W03 User’s Manual

“Reboot” button on the left side or through turning on/off the printer power.

Note: Don’t restart the wireless network parameters “Basic” and “Security” unless all parameters have

been set. If performing the restart operation after having set partial parameters, then this may lead to

abnormal connection of wireless network.

5.7 Button function and restore defaults

Insert thin material into button hole of interface module (see Figure 3.1.1) and keep pressing down the

button for more than 5s to start the printer. Then when the printer starts feeding paper, restore the

factory settings of interface module.

Note:

The interval between starting of printer and printer starting feeding paper is about twenty seconds.

5.8 General procedure of wireless network module connecting configuration

The use of wireless network module needs to connect and configure the wireless network, and the

following is the explanation of general procedure.

Step 1: Restore the parameters of wireless network to factory settings.

Step 2: Build the wireless network connection through the connection of wireless network with wireless

network module.

Step 3: Set the IP address of wireless network card on PC to the same with the network segment of

printer.

Step 4: Search for wireless network interface through the network configuration tool BYNetWinConfig

(V3.07 and above).

Step 5: Configure the wireless parameters and IP parameter of wireless network through the network

configuration tool or the network page of wireless interface board.

Step 6: After finishing the configuration of parameters, restart the wireless interface and then the

wireless interface will use new parameters to connect to the network.