User Manual

JK-W03 User’s Manual
25
Figure 5.6.8 Configuration of wireless basic parameters
In the “Security” page, the encryption mode and the password of wireless network can be set.
Under base station mode, support WEP, WPA-PAK and WPA2-PSK; Under peer-to-peer mode,
support WEP and WPANONE mode.
When adopting WEP encryption, you can select “Open System” and “Shared Key” these two kinds of
mode; when setting to WPANONE, WPA-PSK or WPA2-PSK, you can select “AES” and “TKIP”.
“Disable”: Indicate not adopt encryption mode.
“WEP”: Indicate adopt WEP encryption mode.
“WPANONE”: Indicate adopt the WPANONE encryption authentication mode, and this mode can be
used only under peer-to-peer mode.
“WPA-PSK / WPA2-PSK”: Indicate adopt WPA-PSK or WPA2-PSK encryption authentication mode.
This mode can only be used in the base station wireless network built by wireless router.
“Encryption”: Set the encryption mode used by WPANONE, WPA-PSK and WPA2-PSK to AES or
TKIP.
Key or WPAKey: Used to set the password used by wireless network.
Refer to figure 5.6.9 for the “Security” configuration page:
Figure 5.6.9 Configuration of wireless security information
After making the change, click “Save” to save the setting, and you can also restore the factory default
settings through clicking “Restore Defaults” button. After changing the configuration, you need to
restart the printer to make new configuration valid. You can restart the printer through clicking the