User Manual

JK-W03 User’s Manual
24
through clicking “Restore Defaults” button.
After changing the configuration, restart the printer to make new configuration valid. The restarting of
printer can be carried out through clicking the “Reboot” button on the left, or through turning off/on the
printer power. The configuration page is as follows:
Figure 5.6.7 TCP/IP configuration page
Note:
Only letter or digit can be set as safety password and cannot use special symbols.
Only when wired mode and wireless mode of interface module are valid at the same time, “Wired
TCP/IP” and “Wireless TCP/IP” will show at the same time. Otherwise only one relevant page will
show.
5.6.6 Wireless network parameter setting
Click “Basic” and “Security” link under “Wireless” to enter basic configuration and security
configuration page of wireless parameters.
The following parameters can be set under “Basic” page:
“Region or Domain”: Set the region or domain list of wireless network channel and different options
allow different setting range. The default is “--Default--”
“Network Type” is used to set the type of wireless network. “Ad Hoc” indicates the peer-to-peer
network connected directly with network card and “Infa” indicates the infrastructure network using
wireless router.
“SSID” is used to set the name of wireless network.
“Channel No” is used to set the channel number of wireless network. When adopting peer-to-peer
mode, it needs to be set and there is no need to set it when adopting infrastructure network.
Refer to Figure 5.6.8 for “Basic” configuration page.