User Manual

JK-W03 User’s Manual
14
n Set network parameters like IP address, etc.
After the password verifying passes, enter the window of “Network parameter setting” (see Figure
5.2.8), then the network parameters like IP address can be changed.
Figure 5.2.8 Network parameters configuring window
Through this window, there are two methods to configure the network parameters. One method is “Get
IP address automatically”, and the other method is to set the parameters like IP address manually.
Meantime, you can also change the configuration password, printing port and restore default settings.
After the change, click “OK” to exit from configuration of port and click “Reset” button to wait for restart
of printer and finish changing the configuration.
The factory settings are as follows:
IP address: 192.168.0.200
Subnet mask: 255.255.255.0
Gateway address: 192.168.1.1
DHCP enabled: Disabled
PASSWORD: none
Print Port: 9100
Inactivity time: 5