Manualshelf

User Manual

ManualsBrandsShandong New Beiyang Information Technology ManualsElectronicsWLAN Interface Module
11121314151617181920
JK-W03 User’s Manual
13
Figure 5.2.7 Set wireless parameters window
Region selection: Select different channel region and the channel range used by different regions is
different.
Communication mode: Select the working mode of printer wireless network. The base station mode
(that is, infrastructure network) is the type that using wireless router to build the wireless network. The
peer-to-peer mode (that is, AD-HOC mode) builds the wireless network directly using wireless network
card.
SSID: Name of wireless network. It is used to set the name of wireless network to be connected.
Channel: It is used to set the range of wireless frequency used by wireless network. It needs to be set
only when the communication mode is set to peer-to-peer mode.
Safe mode: It is used to set whether the wireless network has adopted encryption mode. If it is
encrypted, then check this item and carry out detailed settings; If it is not encrypted, then there is no
need to check this item.
Encryption method: Set the encryption method of wireless network. The encryption methods
supported by infrastructure network and peer-to-peer network are different. Under base station mode,
support WEP, WPA-PAK and WPA2-PSK; Under peer-to-peer mode, support WEP and WPANONE
mode.
Wep mode or Wpa mode: It is used to set the encryption mode during WEP and WPA encryption.
When adopting WEP encryption, you can select “Open System” and “Shared Key” these two kinds of
mode; when adopting WPANONE, WPA-PSK or WPA2-PSK, you can select “AES” and “TKIP”.
Wep size: It is used to set the length of encryption key during WEP encryption.
Format of encryption key: It is used to set whether the password selects ASCII or HEX.
Wep data or Wpa data: It is used to set the password during encryption. The length of password
supported by different encryption mode is different. When adopting WPANONE, WPA-PSK or
WPA2-PSK encryption, you can set 8~63 ASCII or 64 HEX.
Note: During the setting of wireless network parameters, be careful that the wireless network
parameters need to be set at one time, and this cannot be separate. If the setting of wireless network
parameters is wrong, this will cause that the wireless module cannot connect to the wireless network
normally. Then the wireless module parameters need to be set again and restore the parameters to
factory defaults.