User Manual

JK-W03 User’s Manual

5.2 Search interface module through configuration tool

Through the BYNetWinConfig.exe (V3.07 and above) tool, you can search the network interface

modules connected to the same network, and configure and change their parameters.

Before running the software, connect the host to the network that the printer is in, and set the network

mode, SSID, and subnet mask of host to make them consistent with interface module. In addition, the

IP address of host should be among the subnet to ensure that the host and the interface module are in

the same subnet.

Note:

While changing the parameters of network interface module through the configuration tool, if there are

several devices with the same IP address in a subnet (for example, several interface modules use the

factory setting), the communication cannot be carried out since the conflict of IP address. Therefore,

when changing the network parameters of the interface module with factory settings, only one network

interface device can be connected each time and ensure that the IP addresses after the change are

not the same.

While configuring the parameters of network interface module, don’t set the same SSID and channel

for network of point-to-point mode and infrastructure mode to avoid abnormal communication.

For detailed usage of network interface module configuration tool, please refer to the following

explanation:

Run BYNetWinConfig.exe, and show the main window of configuration tool (Figure 5.2.1).

Figure 5.2.1 Main window of configuration tool

n Search the printer

Click “Protocol Operation (O

)” in the main window, then the search protocol selection window will pop

up. If selecting IPX/SPX protocol, then you can search the printers connected to the network, which all

adopt JK-W03 interface module; If selecting UDP broadcast protocol, then you can search the JK-W03

interface module printers of different network segments. The search results will show in the list box so