User Manual

JK-W03 User’s Manual
6
5 Device search and parameter configuration
5.1 Connecting wireless module through wireless network
5.1.1 Checking parameters of wireless module
The parameters of the wireless module are the factory default values when receiving the wireless
module for the first time, which can be confirmed by printing the printer self-test page.
Figure 5.1.1 wireless mode self-test page information
The factory settings are as follows:
SSID (wireless network name): defaultSSID
Mode (wireless network mode): AD-HOC
IP Address (IP address): 192.168.0.200
SUBNET Mask (subnet mask): 255.255.255.0
GATEWAY (gateway address): 192.168.1.1
DHCP: Disabled
PASSWORD: none
Print Port: 9100
Inactivity time: 5
If the parameters are not the default values, please connect according to the actual parameters of the
wireless module, and the parameters of wireless module can also be reset to the default values
through the button on the wireless module (please refer to chapter 5.8).
After the wireless network module works normally, it can be connected and configured.