User`s manual

Confidential
RS-T80 Programming Manual
- 91 -
motion unit] inch.
• When characters are enlarged, the right-side character spacing is n times normal value.
• This command sets values independently in each mode (standard and page modes)
• The horizontal and vertical motion unit are specified by GS P. Changing the horizontal or
vertical motion unit does not affect the current right-side spacing.
• In standard mode, the horizontal motion unit is used.
• In page mode, the horizontal or vertical motion unit differs in page mode, depending on
starting position of the printable area as follows：
1) When the starting position is set to the upper left or lower right of the printable area
using ESC T, the horizontal motion unit (x) is used.
2) When the starting position is set to the upper right or lower left of the printable area
using ESC T, the vertical motion unit (y) is used.
• The maximum right-side spacing is 255/180 inches. Any setting exceeding the maximum
is converted to the maximum automatically.
[Default] n = 0
[Demo] 1B 40
1B 20 00（Set right-side character spacing as 0）
41 41 41 41 41 0A
1B 20 06（Set character spacing as 6/203 inch）
42 42 42 42 42 0A
1B 20 0C（Set character spacing as 12/203 inch）
43 43 43 43 43 0A
Results：
ESC ! n
[Function] Select print mode(s)
[Format] ASCII ESC ! n
Hex 1B 21 n
Hecimal 27 33 n
[Range] 0 ≤ n ≤ 255
[Notes] • Selects print mode(s) usiing n as follows
Bit 1/0 HEX Decimal Function
0
0 00
0 Standard ASCII Font (12 × 24)
1 01 1
Compress ASCII Font (9 × 17)
1,2 Undefined