User`s manual

Confidential
RS-T80 Programming Manual
- 82 -
32 32 32 32 32 32 32 32 32 32 32 32 32 32 32 32 32 32 32 32 32 32 32 32 32
0A (newline)
1B 54 03 (select the print area direction in page mode)
33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33
0A（print）
50 72 69 6E 74 20 45 6E 64
0C（print）
Results:
ESC W xL xH yL yH dxL dxH dyL dyH
[Function] · Define the horizontal starting position, vertical starting position, printing area
width, and printing area height.
[Format] ASCII ESC W xL xH yL yH dxL dxH dyL dyH
Hex 1B 57 xL xH yL yH dxL dxH dyL dyH
Decimal 27 87 xL xH yL yH dxL dxH dyL dyH
[Range] 0 ≤ xL, xH, yL, yH, dxL, dxH, dyL, dyH ≤ 255 (except dxL= dxH=0 or dyL=
dyH=0)
[Notes] · If this command is input in standard mode, the printer executes only internal
flag Each the horizontal starting position, vertical starting position, printing
area width, and printing area height are defined as x0、y0、dx、dy setting for
the printing area is calculated as follows:
x0 = [( xL + xH × 256) × (horizontal motion unit)]
y0 = [( yL + yH × 256) × (vertical motion unit)]
dx = [ dxL + dxH × 256) × (horizontal motion unit)]
dy = [ dyL + dyH × 256) × (vertical motion unit)]
The printing area is set as shown in the figure below.
This command does not affect printing in standard mode.