User`s manual

Confidential
RS-T80 Programming Manual
- 79 -
[Relative] ESC D
[Demo] 0A (set the print start position to the beginning of the ling)
1B 40 (initialize printer)
1B 53(enter standard mode)
33 33 33 33 33 33
1B 44 08 10 1C 00（set the horizontal tab position）
09（move the print position to the next tab）
33 33 33 33
09（the same as above）
33 33 33 33
09（the same as above）
33 33 33 33
0A（print）
33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33 33
33 33 33
0A（print）
Results:
ESC $ nL nH
[Function] Sets the distance from the beginning of the line to the position at which
subsequent characters are to be printed.
· The distance from the beginning of the line to the print position is [(nL + nH ×
256) × (vertical or horizontal motion unit)] inches.
[Format] ASCII ESC $ nL nH
Hex 1B 24 nL nH
Decimal 27 36 nL nH
[Range] 0≤nL ≤ 255
0 ≤nH≤255
[Notes] · Settings outside the specified printable area are ignored.
· The horizontal and vertical motion units are specified by GS P.
· In standard mode, the horizontal motion unit (x) is used.
· In page mode, horizontal or vertical motion unit differs depending on the
starting position of the printable area as follows:
1) When the starting position is set to the upper left or lower right of the