User`s manual

Confidential Thermal Printer
RS-T80 Programming Manual
- 55 -
3 Outline and Parts
3.1 Outline and Parts
1—Paper near end sensor adjusting lever
2 —Paper holder
3 —Platen roller
4—Middle cover
5—Bottom cover
6 — Power switch
7—Paper guide
8—Top cover
9 — Cover spanner
10—Printhead
11—Paper roll shaft
12—Printhead support plate
13 —Power connector
14 —Communicate interface
15 —Cash drawer connector
Functions of parts:
a) Paper guide
Removing the paper guide or putting it in a different slot will allow the printer to use
different paper widths listed as follows: 82.5±0.5 mm, 80.5±0.5 mm, 57.5±0.5 mm.
b) Power switch
Switching the power of the printer on or off. “O” power is turned off. “—” power is turned
on.
c) Feed button （See Fig 3.1-3）
Switching on the printer while pressing the FEED button will start the
printing of the configuration table。
 In normal status:
Continuous paper mode:
 The printer will feed one line when pressing the FEED button for
a short time.
 The printer will feed continuously when pressing the FEED button for a longer
time
Marked paper mode:
 The printer will feed one line when pressing the FEED button for a short time.