User`s manual

Confidential Thermal Printer
RS-T80 Programming Manual
- 52 -
2.2 Cutter Specification
Item parameter Note
Cutter type Slide cutter (Guillotine type)
Cutting time 600ms The time that one cut takes
Cutting interval 2s 30 times/min. (Max.)
Paper type
0.06～0.1mm
Thermal paper or paper with the same
thickness
Operation voltage 24VDC
Max. static curren 1.2A 24VDC
Cutter lifetime
2,000,000 cuts (reference paper with
thickness of 0.06 mm)
Full or partial cuts
 Full cut: Cut off the paper completely；

Partial cut: 2 mm paper left in middle
2.3 Paper Specification
2.3.1 Continuous paper
 Paper type: Continuous thermal paper
 Paper supply method: Paper roll
 Paper width: 82.5±0.5mm,80±0.5mm, 57.5±0.5 mm
 Paper thickness: 0.06mm-0.1mm
 Thermal senstive layer: Outside
 Paper roll specifications
OD(MAX): ф100 mm
ID(Min): ф15mm
Caution:
 Do not paste the paper to the core.
 If the paper is contaminated by a chemical or oil, it may discolor or lose heat
sensitivity at the polluted spot.
 Do not rub the paper surface strongly against hard objects, otherwise it may
discolor.
 When the temperature goes up to 70 degrees centigrade, paper will discolor.
 Don’t use or store paper under high temperature, high humidity and strong light
conditions.
2.3.2 Marked paper
In marked paper mode, BTP-R580 determines the cut position and the initial printing
position by referencing the position of the black mark. Black marked paper should meet the
following requirement besides that of standard paper.