User`s manual

Cash Drawer Installation

Before connecting the cash drawer to the MP-2410, please make sure the drive voltage and cable

pin assignment of the cash drawer matches the definition of the cash drawer port of MP-2410.

Please refer to the mother board (BT-05) manual GPIO part for more information. For

programmers, please refer to the Cash Drawer Driver, where you may find the test programs and

DLL Library files for your application.

Plug cash drawer cable into the cash drawer port.

Note: If the cash drawer cannot be detected by the system, please refer to troubleshooting.

Cash_Drawer1: DIO with RJ-11 Connector

PIN No. Signal Description

1 Ground

2 DIO Out 1

3 +12V

4 DIO IN 0

5 DIO Out 0

6 Ground

Up to two cash drawers may be driven from this port. Driving voltage of the solenoid is DC+12V.

I/O port 2F is used for drawer operation. A test program is supplied, for Linux and Windows,

source code of which is available on request by software developers.

Value Description

0x01 GPIO:1, DIO:0

0x2e,0x87,0x2e,0x87,0x2e,0x07,0x2f,0x09,

0x2e,0xf1

Entry commands.

0x2f,0x00 Output address.

0x2f,0x00 Input address.

0x53 Open cashdrawer1 value.

0x33 Open cashdrawer2 value.

0x60 Close cash-drawer value.

0x80 Cash-drawer status mask.