User`s manual

Confidential
RS-T80 Programming Manual
- 137 -
When the LSB of m = 0:
The macro executes r times continuously at the interval specified by t.
When the LSB of m = 1:
After waiting for the period specified by t, the PAPER OUT LED indicators
blink ,and the printer waits for the FEED button to be pressed. After the button
is pressed, the printer executes the macro once. The printer repeats the
operation r times.
[Notes] · The waiting time is t × 100 ms for every macro execution.
· If this command is received while a macro is being defined, the macro
definition is aborted and the definition is cleared.
· If the macro is not defined or if r is 0, nothing is executed.
· When the macro is executed ( m = 1), paper always cannot be fed by using
the FEED button.
[Relative] GS :
GS { w
[Name] Enable\Disable watermark mode
[Format] ASCII GS { w n
Hex 1D 7B 77 n
Decimal 29 123 119 n
[Range ] n = 0、1。
[Description] n = 0：Enable watermark mode;
n = 1：Disable watermark mode.
[Note] • This command should be used at the beginning of the line, otherwise it is not
effective.
• Please use GS { w f to define the bitmap before using this command.
• When disable watermark mode using this command, the printer recovers to
the normal print mode.
GS { w f
[Name] Set watermark bitmap parameters and enter watermark mode.
[Format] ASCII GS { w f n1 n2 n3 n4 n5
Hex 1D 7B 77 02 n1 n2 n3 n4 n5
Decimal 29 123 119 02 n1 n2 n3 n4 n5
[Range] n1 = 0、1；
n2 = 0、1、2；
n3, using the value in figure 1
[Description] • n1 specifies watermark printing mode:
0：To print watermark when paper feed
1: To print watermark when print start