User`s manual

Confidential
RS-T80 Programming Manual
- 133 -
[Note] · Each bit of n is used as follows:
Bit 0/1 Hex Decimal Function
0
0 00 0 Paper near end send is disabled
1 01 1 Paper near end send is enabled
1
0 00 0 Paper near end send is disabled
1 02 2 Paper near end send is enabled
2
0 00 00 Paper near end send is disabled
1 04 4 Paper near end send is enabled
3
0 00 00 Paper near end send is disabled
1 08 8 Paper near end send is enabled
4-7 Undefined
· It is possible to select two sensors to output signals. Then, if any of the
sensors detects a paper end, the paper end signal can output.
· The command is available only with a parallel interface and is ignored with a
serial interface.
· If either bit 0 or bit 1 is on (value is 1), the paper near-end sensor is selected
as the paper sensor outputting paper-end signals.
· If either bit 2 or bit 3 is on (value is 1), the paper end sensor is selected as the
paper sensor outputting paper-end signals
· When two sensors are disabled, the paper end signal always outputs a paper
present status.
[Default] n = 12
ESC c 4 n
[Function] Select paper sensor(s) to stop printing
[Format] ASCII ESC c 4 n
Hex 1B 63 34 n
Decimal 27 99 52 n
[Range] 0 ≤ n ≤ 255
[Notes] n is defined as below:
Bit Off/On Hex Decimal Function
0
Off 00 0 Paper near end sensor disabled
On 01 1 Paper near end sensor enabled
1
Off 00 0 Paper near end sensor disabled
On 02 2 Paper near end sensor enabled
2-7 Undefined
· When either bit 0 or 1 is on, paper near-end sensor enabled, and it stops
printing after printer the current task.
[Default] n = 0