User`s manual

Confidential
RS-T80 Programming Manual
- 131 -
[Notes] · This command is effective only in page mode.
· Data buffered in page mode are cleared.
· This command sets the print position to the beginning of the line.
· The page area are initialized as default data.
· This command switches the settings for the following commands (in which the
values can be set independently in standard mode and page mode) to those
for standard mode:
1)Set right-side character spacing: ESC SP, FS S
2)Select default line spacing: ESC 2, ESC 3
· The following commands are enabled only to set in standard mode.
1)Set printing area in page mode: ESC W
2)Select print direction in page mode: ESC T
· The following commands are ignored in standard mode.
1)Set absolute vertical print position in page mode: GS $
2)Set relative vertical print position in page mode: GS \
· Standard mode is selected automatically when power is turned on, the printer
is reset, or command ESC @ is used.
[Relative] FF, ESC FF, ESC L
ESC c 0 n
[Function] Selects the paper type
[Format] ASCII ESC c 0 n
Hex 1B 63 30 n
Decimal 27 99 40 n
[Range] 0 ≤ n ≤ 2
[Notes] Selects the paper type
n = 0, set paper type as continuous paper roll.
n = 1, set paper type as Marked paper.
·Marked paper is the paper with black marks.
Never use marked continuous paper when paper type is set to paper,
otherwise GS FF command will cause the printer feeding too long. Never use
marked paper when paper type is set to continuous paper, otherwise printer
will alarm paper end.
[Default] n = 0
[Relative] GS FF
ESC c 3 n
[Function] Select paper sensor(s) to output paper end signals
[Format] ASCII ESC c 3 n
Hex 1B 63 33 n
Decimal 27 99 51 n