User`s manual

Confidential
RS-T80 Programming Manual
- 129 -
ESC @
[Function] Initialize printer
[Format] ASCII ESC @
Hex 1B 40
Decimal 27 64
[Notes] · The data in the receive buffer is not cleared.
· The macro definition is not cleared.
· The NV bit image data is not cleared.
ESC L
[Function] Select page mode
[Format] ASCII ESC L
Hex 1B 4C
Decimal 27 76
[Notes] ·This command is enabled only when processed at the beginning of a line in
standard mode.
·This command has no effect in page mode.
·After printing by FF is completed or by using ESC S, the printer returns to
standard mode.
·This command sets the position where data is buffered to the position
specified by ESC T within the printing area defined by ESC W.
·This command switches the settings for the following commands (in which the
values can be set independently in standard mode and page mode) to those
for page mode:
1)Set right-side character spacing: ESC SP, FS S
2)Select default line spacing: ESC 2, ESC 3
· Only indication bit can be changed in page mode; switch to standard mode
are not executed.
1)Turn 90° clockwise rotation mode on/off: ESC V
2)Select justification: ESC a
3)Turn upside-down printing mode on/off: ESC {
4)Set left margin: GS L
5)Set printable area width: GS W
·The printer returns to standard mode when power is turned on, the printer is
reset, or ESC @ is used.
[Relative] FF, CAN, ESC FF, ESC S, ESC T, ESC W, GS $, GS \
ESC S
[Function] Select standard mode
[Format] ASCII ESC S