User`s manual

ManualsBrandsShandong New Beiyang Information Technology Co. ManualsComputer equipmentBTP-R580?

121

122

123

124

125

126

127

128

129

130

Confidential

RS-T80 Programming Manual

- 121 -

CODABAR 1 ≤ n ≤ 255

48 ≤ d ≤ 57 65 ≤ d ≤ 68, 36, 43,45,46,47 58

CODE93 1 ≤ n ≤ 255

0 ≤ d ≤ 127

CODE128 2 ≤ n ≤ 255

0 ≤ d ≤ 127

75 PDF417 1 ≤ n ≤ 255 0 ≤ d ≤ 255

[Notes ①]

· This command ends with a NULL code.

·When UPC-A or UPC-E selected, printer ignores the following data after

receiving 12 bytes of barcode data.

·When JAN13 (EAN13) selected, printer ignores the following data after

receiving 13 bytes of barcode data.

·When JAN8 (EAN8) selected, printer ignores the following data after receiving

13 bytes of barcode data.

· The number of data for ITF bar code must be even numbers. When an odd

number of data is input, the printer ignores the last received data.

· The beginning code and the ending code of CODEBAR barcode must be one

of A, B, C and D. The ending codes can use T, E, * and N to ends.

[Notes ]②

· n indicates the number of barcode data, and the printer processes n bytes

from the next character data as barcode data.

· If n is outside of the specified range, the printer stops command processing

and processes the following data as normal data.

[Notes ( standard mode)]

· If d is outside of the specified range, the command is ignored.

· If the horizontal size of the barcode exceeds printing area, the command is

ignored.

· This command feeds as much paper as is required to print the barcode,

regardless of the line spacing specified by ESC 2 or ESC 3.

· This command is enabled only when no data exists in the print buffer. When

data exists in the print buffer, the command is ignored.

· After printing barcode, this command sets the print position to the beginning of

the line.

· This command is not affected by print modes (emphasized, double-strike,

underline, character size, white/black reverse printing, or 90° rotated character,

etc.), except for upside-down printing mode.

[Notes in page mode]

· This command develops bar code data in the print buffer, but does not print it.

After processing barcode data, this command moves the print position to the

right side dot of the barcode.