User`s manual

Confidential
RS-T80 Programming Manual
- 114 -
· This command defines n as the number of a NV bit image. Numbers rise in
order from NV bit image 01H. Therefore, the first data group [xL xH yL yH
d1...dk] is NV bit image 01H, and the last data group [xL xH yL yH d1...dk] is
NV bit image n. The total agrees with the number of NV bit images specified by
command FS p.
· A definition data of a NV bit image consists of [xL xH yL yH d1...dk]. Therefore,
when only one NV bit image is defined n=1, the printer processes a data group
[xL xH yL yH d1...dk] once. The printer uses ([data: (xL + xH × 256) × ( yL + yH
× 256) × 8] + [header:4]) bytes of NV memory.
· The download area in Flash of this printer is a maximum of 64K bits (8K bytes).
This command can define several NV bit images, but cannot define a bit image
data whose total capacity [bit image data + header] exceeds 64K bits (The
download area is different according to different configuration).
· The printer is busy immediately before writing into Flash.
· When this command is received during macro definition, the printer ends
macro definition, and begins performing this command.
· Once a NV bit image is defined, it is not erased by performing ESC @, reset,
and power off.
· This command performs only definition of a NV bit image and does not
perform printing. Printing of the NV bit image is performed by the FS p
command.
[Relative] FS p
[Demo] When xL = 64, xH = 0, yL = 96, yH = 0