User`s manual

Confidential
RS-T80 Programming Manual
- 113 -
Decimal 28 113 n [xL xH yL yH d1...dk]1...[ xL xH yL yH d1...dk]n
[Range] 1 ≤ n ≤ 255
0 ≤ xL ≤ 255
1 ≤ ( xL + xH × 256) ≤ 1023
1 ≤ ( yL + yH × 256) ≤ 8190
0 ≤ d ≤ 255
k = ( xL + xH × 256) × ( yL + yH × 256) × 8
[Notes] ·Define the NV bit image specified by n. The max capacity of Flash is
256K( May be less than 256K according to different configuration).
· n specifies the number of the defined NV bit image.
· xL, xH specifies ( xL + xH × 256) × 8 dots in the horizontal direction for the NV
bit image you are defining.
· yL, yH specifies ( yL + yH × 256) × 8 dots in the vertical direction for the NV bit
image you are defining.
· Frequent write command execution may cause damage the NV memory.
Therefore, it is recommended to write the NV memory 10 times or less a day.
·This command cancels all NV bit images that have already been defined by
this command. The printer can not redefine only one of several data definitions
previously defined. In this case, all data needs to be sent again.
· Before the ending of the processing of this command mechanical operations
(including initializing the position of the printer head when the cover is open,
paper feeding by using the FEED button, etc.) cannot be performed, also
sending command including real-time command is forbidden.
NV bit image means a bit image which is defined in a non-volatile memory by
FS q and printed by FS p.
· In standard mode, this command is effective only when processed at the
beginning of the line.
· This 7 bytes <from FS~yH> is command data but not data of image.
· When the amount of data exceeds the capacity left in the range defined by xL,
xH, yL, yH, the printer processes xL, xH, yL, yH out of the defined range.
· In the first group of NV bit images, when any of the parameters xL, xH, yL, yH
is out of the definition range, this command is disabled.
· In groups of NV bit images other than the first one, when the printer processes
xL, xH, yL, yH out of the defined range, it stops processing this command. At
this time, NV bit images that haven’t been defined are disabled (undefined),
but any NV bit images before that are enabled.
· The d indicates the definition data. In data (d) a 1 bit specifies a dot to be
printed and a 0 bit specifies a dot not to be printed.