User`s manual

Confidential
RS-T80 Programming Manual
- 110 -
· If x × y is out of the specified range, this command is disabled.
· The d indicates bit-image data. Data (d) specifies a bit printed to 1 and not
printed to 0.
· The downloaded bit image definition is cleared when:
1)Printer is reset or the power is turned off.
· The following figure shows the relationship between the downloaded bit image
and the printed data.
[Relative] GS /
GS / m
[Function] Print downloaded bit image
[Format] ASCII GS / m
Hex 1D 2F m
Decimal 29 47 m
[Range] 0 ≤ m ≤ 3, 48 ≤ m ≤ 51
[Description] Prints a downloaded bit image using the mode specified by m.
m selects a mode from the table below:
m Mode Vertical Resolution (DPI) Horizontal Resolution (DPI)
0, 48 Normal 203 203
1, 49 Double-width 203 101
2, 50 Double-height 101 203
3, 51 Quadruple 101 101
[Notes] · This command is ignored if a downloaded bit image has not been defined.
· In standard mode, this command is effective only when there is no data in
the print buffer.
· This command has no effect in the print modes (emphasized, double-strike,
underline, character size, or white/black reverse printing), except for
upside-down printing mode.
· If the downloaded bit-image to be printed exceeds the printable area, the
excess data is not printed.