User`s manual

Confidential
RS-T80 Programming Manual
- 108 -
Number of Dots Dot Density Dot density Number of Data (K)
0 8-dot single-density 8 203/3 DPI 101 DPI
nL + nH × 256
1 8-dot double-density 8 230/3 DPI 203 DPI
nL + nH × 256
32 24-dot single-density 24 203 DPI 101 DPI
( nL + nH × 256) × 3
33 24-dot double-density 24 203 DPI 203 DPI
( nL + nH × 256) × 3
[Notes] ·If the values of m is out of the specified range, nL and data following are
processed as normal data.
· The nL and nH indicate the number of dots of the bit image in the horizontal
direction. The number of dots is calculated by nL + nH × 256.
· If the bit-image data input exceeds the number of dots to be printed on a line,
the excess data is ignored.
· d indicates the bit-image data. Set a corresponding bit to 1 to print a dot or to 0
to not print a dot.
· After printing a bit image, the printer returns to normal data processing mode.
·This command is not affected by print modes (emphasized, double-strike,
underline, character size or white/black reverse printing), except upside-down
printing mode.
· The relationship between the image data and the dots to be printed is as
follows:
· When 8-dot bit image is selected:
When 24-dot bit image is selected: