User`s manual

Confidential
RS-T80 Programming Manual
- 107 -
[Relative] GS P
[Demo] Refers to ESC SP
FS W n
[Function] Turn quadruple-size mode on/off for Kanji characters
[Format] ASCII FS W n
Hex 1C 57 n
Decimal 28 87 n
[Range] 0 ≤ n ≤ 255
[Description] · When the LSB of n is 0, quadruple-size mode for Kanji characters is turned
off.
· When the LSB of n is 1, quadruple-size mode for Kanji characters is turned
on.
[Notes] · Only the lowest bit of n is valid.
· In quadruple-size mode, the printer prints the same size characters as when
double-width and double-height modes are both turned on.
· When quadruple-size mode is turned off using this command, the following
characters are printed in normal size.
· When some of the characters on a line are different in height, all the
characters on the line are aligned at the baseline.
· FS ! or GS ! can also select and cancel quadruple-size mode by selecting
double-height and double-width modes, and the setting of the last received
command is effective.
[Default] n = 0
[Relative] FS !, GS !
2.4 Bitmap Command
ESC * m nL nH d1... dk
[Function] Select bit-image mode
[Format] ASCII ESC * m nL nH d1...dk
Hex 1B 2A m nL nH d1...dk
Decimal 27 42 m nL nH d1...dk
[Range] m = 0, 1, 32, 33
0 ≤ nL ≤ 255
0 ≤ nH ≤ 3
0 ≤ d ≤255
[Notes] Selects a bit-image mode using m for the number of dots specified by nL and
nH, as follows:
m Mode Vertical Direction Horizontal Direction