User`s manual

Confidential
RS-T80 Programming Manual
- 106 -
FS S n1 n2
[Function] Set left-side and right-side Kanji character spacing
[Format] ASCII FS S n1 n2
Hex 1C 53 n1 n2
Decimal 28 83 n1 n2
[Range] 0 ≤ n1 ≤ 255
0 ≤ n2 ≤ 255
[Description] Sets left-side and right-side Kanji character spacing to n1 and n2
respectively.
When the printer model used supports GS P, the left-side character spacing
is [ n1 × horizontal or vertical motion units], and the right-side character
spacing is [ n2 × horizontal or vertical motion units].
[Notes] When double-width mode is set, the left-side and right-side character spacing
is twice the normal value.
The horizontal and vertical motion units are set by GS P. The previously
specified character spacing does not change, even if the horizontal or vertical
motion unit is changed using GS P.
· In standard mode, the horizontal motion unit is used.
· In page mode, the horizontal or vertical motion unit differs in page mode,
depending on starting position of the printable area as follows:
1) When the starting position is set to the upper left or lower right of the
printable area, the horizontal motion unit ( x) is used.
2) When the starting position is set to the upper right or lower left of the
printable area, the vertical motion unit ( y) is used.
3) The maximum Chinese Kanji spacing is approximately 36 mm. Any setting
exceeding the maximum is converted to the maximum automatically.
[Default] n1 = 0, n2 = 0