Setup

Installation Instruction for Shadow SH 2500 E
Concealed Permament Mount Transducer
Fax: [phone]
eMail: [e-mail]
Shadow Elektroakustik
Peter-Haendel Straße 2
91334 Hemhofen · Germany
Shadow Electronics of America Inc.
17791 Alexander Run
Jupiter, FL 33478 U.S.A.
Fax: +49 - 91 95 - 92 99 30
eMail: [e-mail]
Content:Content:
Transducer with 25cm cable (3.5mm)
endpin (6.3mm / 3.5mm)
mounting adhesive
Note:
Piezo pickups and transducers have a very high output impedance. In order to get the optimum sound output we
recommend an amplifier with low impedance input.
Fig. 1
1. Remove strings and original endpin.
2. Drill a 7/16” (11mm) hole using the original endpin hole as a pilot.
3. Slightly bevel the edges of the hole to avoid cracking the finish.
4. Press the endpin into the hole until it is flush with the body.
5 . Apply an even amount of included adhesive to the bottom of the pickup.
6. Locate the pickup under the bridge between the second and third strings (B2-G3). See suggested locations in fig. 1.
7. Use gentle but firm pressure to apply the pickup.
8. Connect the pickup output into the endpin jack input.
9. Reinstall strings and retune.
1
3
2