Owner's Manual
fshadaw-casler.i:am
~
LED
LIGHTING
Changing Colors
Zone
Controller
Remote
OPERATION"
GUIDE
Select desired zone(s) and press a
colorO
- - -
Or press G or · to advance to the next color and previous color
in
the color index.
Example:
fD
then - turns All Zone red.
Returning to a previous setting after powering
off
If the remote gets powered off and you would like to restore the settings you previously
applied, simply click the ALL button twice.
fa
then
fa
Changing Modes
Press the
Cl>
button to change between various effects.
1.
Single Color Fade - The selected color will fade off and
on
.
fshadaw-casler.i:am
~
LED LIGHTING
Color Table
Cool White
Neutral White
2. Multi-Color Fade - Fades up and down and cycles between colors depending
on
selected color sequence. Currently 3 sequences are available.
a. Blue I White
b. Red I Green I Blue I White
c. All Colors
3. Multi-Color Change - Similar to Multi-Color Fade, but maintains brightness
on
a
color before fading to the next color.
4.
Strobe I Flash - Flashes a specified color at a specified rate.
a.
To adjust the color
of
a mode, use the G
or
O buttons.
b. To adjust the speed, HOLD the O button and use the G or 0
Music Sync
Select the desired zone(s) and press the
CD
button to activate music sync.
There are 3 different music sync modes.
1. Full Color Frequency - Different frequency ranges from the music drive the
intensity
of
different colors
2.
Single Color Amplitude - Brightness
of
lights
is
driven
by
different intensity
of
the
music.
In
this mode you can use the
GorOto
change colors
3. Multi-Color Amplitude - Similar to Single Color Amplitude, but colors are rotating
continuously.
In
music sync mode there are additional settings you can adjust to allow for better synchronization
of
the lights to your
music.
Press and hold
CD
and then use the G or ·O buttons to increase or decrease how quickly the lights respond to music
input.
Press and hold
CD
and then use the O or O to increase or decrease sensitivity.
For Best Results
To
calibrate
your
music sync sensitivity, it's recommended that you pause any music, and hold • and press the G button repeatedly to bring the sensitivity to
minimum. Next, while sti
ll
holding
CD
, press the O button to step the sensitivity up one step at a time. When the lights begin reacting, step down once. This way the
sensitivity is as high as possible without being too high. If the sensitivity is too high, the lights will react even when no sound is playing - and
if
the sensitivity is too low, the
lights may not respond at all to the music.
*Depending on the volume
and
speaker system
th
at
you use,
your
settings
may
va,y - so ex
per
iment and adjust as needed
r-w-ca6htr.cam
l-
LED LIGHTING
SCM-ZC-REMOTE
Operation Guide
2
of2
Shadow-Cast
er
LED Lighting
727-474-2877
2060 Calumet St, Clearwater, FL 33765