Tus neeg siv phau ntawv
SWH - Movement Sensor Device - Installation and
configuration Manual
6/(7)
Prod. #
Doc. #
Rev
Date
Author
010103
03
A
16/03/2022
SMV
SGS - IOT COMPETENCE CENTER
This document and information contained in it are confidential and are the property of Société Générale de Surveillance (SGS). They may not in any
way be disclosed, copied, or used by anyone except as expressly authorized by SGS. The document should always be kept in a secure place and
should be destroyed or returned to SGS when it is no longer needed.
6. Change ACK
To disable or enable the ACK send by the gateway screen you have to send 1 byte (00 / 01) respectively on Port 9.
7. Test
To show the downlink message via UART send the ‘x’ bytes on Port 10.
8. Accelerometer configuration
To configure the accelerometer you have to send 4 bytes (according to the table) on Port 11.
9. Accelerometer RAW configuration
To configure the registers of the accelerometer you have to send blocks of 2 bytes (according to the table) on Port
12.
Example:
- Default configuration: 20 27 21 01 22 40 23 00 24 08 25 00 30 7F 32 1A 33 01
- ODR to 5276 Hz: 20 97 21 01 22 40 23 00 24 08 25 00 30 7F 32 1A 33 01