Tus neeg siv phau ntawv

SWH - Movement Sensor Device - Installation and
configuration Manual
4/(7)
Prod. #
Doc. #
Rev
Date
Author
010103
03
A
16/03/2022
SMV
SGS - IOT COMPETENCE CENTER
This document and information contained in it are confidential and are the property of Société Générale de Surveillance (SGS). They may not in any
way be disclosed, copied, or used by anyone except as expressly authorized by SGS. The document should always be kept in a secure place and
should be destroyed or returned to SGS when it is no longer needed.
2.1 INSTALLATION
To carry out the installation of the device, perform the following steps.
1. Checklist
Unpack the package, check the part list to ensure nothing is missing.
2. Activate the device
By default, the device is deactivated. To activate it, pass the magnet for 3 seconds in the reed area (one beep
per second will be generated). When it is connected to the LoRa gateway, the device will emit a long beep and
will send the first frame.
3. Check the device is connected and sending data
You can check the status of the device by passing the magnet for one second, after that:
- If it beeps 3 times, it will indicate that it is working and will send a frame.
- If it beeps 5 times, it is deactivated.
2.2 CONFIGURATION
The device is already configured so it is not need it to carry out the configuration.
3 LORAWAN SENSOR INSTALLATION
In this section, the installation process of the device is explained. Before installing, please check the part list to ensure
nothing is missing.
3.1 PACKING LIST
a. Case 1
b. Case 2
c. Magnet
4 LORAWAN SENSOR CONFIGURATION
In this section, the configuration of the device is explained.
4.1 DEFAULT CONFIGURATION
By default, the device is deactivated. To activate it, pass the magnet for 3 seconds in the reed area (one beep per second
will be generated). When it is connected to the LoRa gateway, the device will emit a long beep and will send the first
frame.
From that moment on, the device will only send data in the following situations:
- If the time set to perform a keep alive arrives, indicating that the device is still working.
- If the magnet is passed over the reed for 3 consecutive seconds.
- If the device moves and the accelerometer alarm is triggered, sending a message when it starts to move and
another one when it finishes moving within a 5 second window.
To deactivate the device, the magnet must be passed for 5 seconds, after this, the device will send a deactivation frame
and will go to sleep.