User Manual

SWH - Grain Condition Monitoring Device - Installation
and configuration Manual
9/(10)
Prod. #
Doc. #
Rev
Date
Author
010102
03
C
02/09/2022
SMV
SGS - IOT COMPETENCE CENTER
This document and information contained in it are confidential and are the property of Société Générale de Surveillance (SGS) . They may not in any
way be disclosed, copied, or used by anyone except as expressly authorized by SGS. The document should always be kept in a secure place and
should be destroyed or returned to SGS when it is no longer needed.
7 CERTIFICATIONS
7.1 CE
The product is in conformity with the essential requirements and other relevant requirements of the R&TTE Directive
(1999/5/EC) and the 2002/95/CE Directive. The product is in conformity with the following standards and/or other
normative documents:
- Electro-Magnetic Compatibility:
- UNE-EN 61326-1.
- Spectrum:
- EN 300 220-1.
- EN 300 220-2.
- Electrical Security:
- UNE-EN 61010-1.
7.2 FCC
The verification of compliance is based on tests conducted by SGS-CSTC Standards technical Services Co., LtD, on
submitted samples of above mentioned product and found to comply with the technical requirement regulations for
the evaluation of electromagnetic compatibility.
FCC Warning:
Please take attention that changes, or modification not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
8 SAFETY PRECAUTIONS
Follow the next safety instructions:
• In document, the term Grain Condition Monitoring Device v3 encompasses both the MTU and the RTU unit with
their sensors.
• Never submerge the device in any liquid.
• Keep the device in a dry place and away from any liquids that might spill.
• Grain Condition Device contains electronic components that are highly sensitive and can be accessed from outside;
handle the device with great care and avoid hitting or scratching any of the surfaces.
• Do not let the electronic parts come into contact with any steel elements, to avoid injuries and burns.
• Do not remove any of the connectors.
• Check the product specifications section for the maximum allowed power voltage and amperage range and always
use batteries that work within that range.
Important: It is the responsibility of the installer to find out about restrictions of use for frequency bands in each
country and act in accordance with the given regulations. SGS does not list the entire set of standards that must be
met for each country.