User guide

Flash Function:
The flash master must be put to full.
If the button underneath a channel is pressed when the flash master is raised then the
channel will flash to the level of the flash master.
Solo function:
If the Solo button is enabled (LED lit) then all other channels will be blacked out leaving
only the channel flashed.
Link function:
A channel can be isolated from the control of Master A and B and connected directly
through the Grand Master.
1. Press and hold down the Link button,
2. Rise the slider of the required channel on preset A to the level required
3. Release the Link key
4. This channel is now controlled by the Grand Master and will be unaffected by any cross-
fades on the A and B masters.
5. To release the channel, press and hold the Link key again, and press the button
underneath the channel to release it.
8
SGM Light Technology 23/08/1999 Ver. 2.00