User guide

STUDIO SC USER GUIDE
The light gray faders, keys and printing, identify this section.
There are 12 (STUDIO 12 SC) or 24 channels (STUDIO 24) available and two presets , A
and B.
The single or double preset:
There are two ways to set the manual presets of your Studio lighting desk:
The SINGLE PRESET operating mode; your Studio can control the double quantity of
dimming channel it normally does (24 channels for Studio 12; 48 channels for Studio 24).
In this case the fader Master Preset A act like the Master fader while the fader Master
Preset B is not active. As the 12 (or 24) LEDS above the channel's fader are not enough
to show the light output of the scene for all the channels, the Flash button A and B are
used for the purpose.
Then, pushing the button A the LEDS will display the light output of the first 12 (or24)
channels, while pushing the button B
, the second group of 12 (or 24) channels will be displayed.
The DOUBLE PRESET operating mode; your Studio desk controls the standard channels it is
designed for.
In this case the Master Preset An acts on preset A is the top one, while the Master Preset
B on preset B, which is the bottom one.
To set the Single or Double Preset:
1. Living the Studio OFF, push and keep pressed the buttons A, B, MODE;
2. Switch On the desk;
3. Wait few seconds until the red led of the Direct button is ON, then release the above3 buttons.
4. Now the Studio is ready to be used.
To operate a show manually:
1. Set up a scene on A preset, using the faders to set the levels required.
2. Set the Grand Master to full
3. Raise the Master Preset A to full to output the scene
4. Set up the next scene on the B preset
5. Cross-fade between the two presets when required, by moving the faders so that A is at
zero and B is at full
6. Both the masters must be enabled to perform this operation. When a master is enabled,
the LED is lit on the button below the fader.
To operate a show using the GO function:
The Go function can be defined as a manual cross-fade timer function.
1. Set up the first scene on preset A, and then the next scene on preset B
2. Enable A master preset (LED lit) and disable B master preset (LED not lit)
3. Set a time using the manual preset cross time knob
4. Set both masters to full, scene A is now shown
5. When the cross fade is required, press both the buttons, A and B simultaneously. A now
is disabled and B enabled, and the fade will occur according to the time set.
6. A new scene can now be set up on preset A and the process repeated.
SGM Light Technology 12/12/2000 Ver. 2.04
7