User guide

STUDIO SC USER GUIDE

5. To modify the scanning area, press the light gray button under the one of the 4 small

corner symbols, showed on the display, then move the joystick to the required new

corner.

6. To store the new mirror position, press the button again. Operating areas can be

created as required, regular or irregular scanning areas can be created.

7. Press the Util button to store the settings and leave Working Area menu.

To test a new Working Area

1. Press the Util button.

2. Scroll with the scroll buttons until “Working Area” appears on the display.

3. Press the light gray button corresponding to Test writing showed on the display

4. Check the scanning area to be tested by moving the joystick

5. Press the Util button to leave Working Area menu.

SGM Light Technology 12/12/2000 Ver. 2.04