User guide

To fade in/out a Register in a set time:
The Registers can be either AND or OR mode.
1. Disable the Register (press the button under the Register fader so that the LED does
not dimly flash)
2. Raise the Register fader to full (there will be no output)
3. Set the time required using the registers cross time knob by turning it to the number
of seconds or minutes required.
4. Press the button underneath the Register, the scene will now fade in to time and the
LED will fade to full strength over time
5. To fade out, press the button again
To cross fade between Registers:
Put the Registers into OR mode (red flashing LED)
1. Fade in the first scene as above
2. Disable second scene (button under register not lit)
3. Rise second Register to full
4. Set the time of the cross fade using the Register cross time knob
5. Press button under the Register of the second scene
6. The Registers will cross fade between them to time
To add a register to another to time:
Put the Register to be added into AND mode (red lit LED).
1. Fade in the first scene as above
2. Disable second scene to be added (button under register not lit)
3. Raise second Register to full
4. Set the time of the cross fade using the Register cross time knob
5. Press button under the Register of the second scene, it will be added to the existing
scene to time
6. Press button again to fade it out
14
SGM Light Technology 23/08/1999 Ver. 2.00